Performance | Input and Output Connectors |
- Voltage Output Range,
- DC : 0 – 1000 V
- AC : 0 – 50 Vp
- Output Current Range,
- DC : 0 – 80 A
- AC : 0 – 50 Ap, 200 Ap
- Ripple Bandwidth : 10 Hz ~ 200 kHz
- DC Source Impedance : 0.4 ~ 650 Ω*
- Operation
- AC : 4-quadrant, bi-polar operation
- DC : 2-quadrant, bi-directional operation
- Output Rise Time, DC Supply: 10 ms from 10% to 90% of full-scale voltage
* For high-voltage ripple testing, this impedance value will change. | - System
- Output, DUT Supply +/- : High-voltage barrier block connectors, accepts up to 6 AWG
- Voltage Monitor : Unbalanced BNC connector; 20V/V
- Current Monitor : Unbalanced BNC connector; 20A/V
- Keyboard : USB connector on cabinet back
- Mouse : USB connector on cabinet back
- USB Drive : USB connector on cabinet back
- Video Output : HDMI connector on cabinet back
- LAN : RJ-45 connector on cabinet back
Signal Generator - Signal Input : Unbalanced BNC used for factory diagnostics
- Signal Output : Unbalanced BNC (analog – 10Vp)
DC Supply : USB port for factory configuration
|
Controls | Protection |
- Software
- Trigger : User, GPIO or LAN
- Loop : Fixed, variable, scripted variable
- Template : Creation and playback
- Remote Output : GPIO or LAN
- Signal Generator : Front-panel on/off power switch
- Amplifier : Front-panel Run/Standby switch
- DC Supply : Front-panel push button for factory configuration
| - Amplifier
- Over/Under Voltage : ±10% from specified supply voltage amplifier is forced to Standby
- Over Current : Breaker protection on both main power and low-voltage supplies
- Over Temperature : Separate output transistor, heat sink, and transformer temperature monitoring and protection
- DC Supply
- Over Voltage : Adjustable 0 – 110% UNominal
- Over Current : Adjustable 0 – 110% INominal
- Over Power : Adjustable 0 – 110% PNominal
- Over Temperature : DC output shuts down in case of insufficient cooling
|
Physical Characteristics | Status Displays |
- AC Supply Requirements : 3-phase 400V-480V AC ±10%, 30A, 50/60 Hz
- Operating Environment
- Temperature : 10°C to 50°C (50°F to 122°F), Maximum output power de-rated above 30°C (86°F).
- Humidity : 70% or less, non-condensing
- Atmospheric Pressure : 86 kPa (860 mbar) to 106 kPa (1,060 mbar)
- Cooling : Forced-air fans
- Dimensions (HxWxD) : 126.09 x 56.44 x 100.53 cm
- Weight: Approximately 136 kg
| - Signal Generator : LEDs for Power, System Fault, Signal-In Enabled
- Amplifier : LEDs for Run/Standby status, Signal presence/Overload condition, Power Supply Fault, Overtemp/Over Current
- DC Supply : LEDs for Power, Remote control, Error, CC operation, DC output On, DC output Off
|
